46
P1512137 R3
Important
After the initial start-up and inspection, the conveyor should be shut down and visually inspected
(see Maintenance Section) after approximately ten hours of operation.
6.3. Operation - Electric Motor Models
Æ
When equipped with an Electric Motor:
1. Turn the electric motor on.
2. Run until the conveyor is empty.
3. Turn off motor and lock out power source.
4. Unplug the power cord, wrap around the equipment and secure to prevent dragging, especially when
transporting or placing the conveyor.
6.4. Operation - Gas Engine Models
Æ
When Equipped with a Gas Engine:
1. If the drive belts are tight, disengage the belts.
2. Start the gas engine. Follow instructions provided with the gas engine for specific starting instructions.
3. Engage belt drive lever (when equipped).
Note
The drive belt should be just tight enough to not slip on the drive pulley. If the belt is too loose, it
will slip, lowering power transfer from the engine and possibly causing a squealing sound. If the belt
is too tight, it will cause excess wear.
4.
Note
The drive belt should be just tight enough to not slip on the drive pulley. If the belt is too loose, it
will slip, lowering power transfer from the engine and possibly causing a squealing sound. If the belt
is too tight, it will cause excess wear.
5. Adjust gas engine to provide maximum engine RPM.
6. Run until all grain has been emptied from the equipment.
7. Reduce engine speed to low idle.
8. Shut off engine and lock out power source.
9. Shut off fuel supply.
6.5. Operation - PTO Drive
1. Attach the PTO driveline securely to the tractor and confirm the connection to the conveyor shaft is secure.
2. Confirm the PTO driveline rotating shield and other shields/guards are in place and in good working order.
S-DRIVE STANDARD CONVEYOR – PORTABLE GRAIN BELT CONVEYOR
