AGFEO AS 1x, Manual

Page: 183 / 228

3 - 3
Programming your
System
ST 25 DECT 30 ST 30
Programming via PC
After installation, your telephone system is prepared to enable you to immediately conduct
telephone calls in the usual fashion and to directly benefit from further advantages of the
system. However, the system allows diverse programming possibilities so you can
configure it to suit your very own personal leads. Without needing to have any knowledge of
a programming language, you can program the telephone system from a PC connected via
the RS 232 C interface or from a PC with an ISDN card connected via the internal S0 bus.
Easily understandable menus guide you through the configuration program. The
configuration software is on the included CD ROM.
System requirements
- IBM- or compatible PC with hard disk and CD ROM drive
- Pentium II 233 MHz or higher
- at least 64 MB RAM
- Microsoft Windows 98/2000/ME/XP
- RS 232 C-or USB interface
Connecting a PC
Connect the telephone system’s RS 232 interface (D-SUB-9 socket) to the PC’s COM
port. Use a 1:1 V.24 plug socket extension lead for connection. It must not be longer than
3 m.
Start the configuration program.
Configure the telephone system. Your inputs are accepted interactively by menu prompting.
After completing configuration, remove the cable from the telephone system
Telefonanlage
(9pol. Stecker)
2
3
5
7
8
PC
(9pol. Buchse)
2
3
5
7
8
Telefonanlage
(9pol. Stecker)
2
3
5
7
8
PC
(25pol. Buchse)
2
3
4
5
7