P - 16
Programming
Enter system PIN?
If you hear the Acknowledgement tone after
*PRO
, the system PIN is switched off in the
telecommunications system. There is no need to
enter the system PIN.
If you do not hear any tone after
*PRO
, a sys-
tem PIN is programmed in the telecommunications
system. Enter the 4-digit system PIN. You will hear
the Acknowledgement tone if the PIN is correct. If
the PIN is incorrect, you will hear the error tone
(busy tone). Replace the handset and start the input
again from the beginning.
h * A N L
q
ª
Lift
handset
Programming a system PIN ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢
System pin
Enter PIN ID and
4-digit system
PIN
Replace
handset
Acknowledge-
ment tone
Protecting the programming mode and switch box against
unauthorised access
You can prevent unauthorised access to the pro-
gramming mode with a system PIN (
P
ersonal
I
den-
tity
N
umber).
You can prevent unauthorised access to the switch
box by a box PIN.
System PIN
– Normally every subscriber can pro-
gram. With the 4-digit system PIN, you can prevent
unauthorised starting of the programming mode.
This protects your telecommunications system set-
tings (e.g. authorisation of the internal subscribers)
against unwanted changes.
Programming is only possible when the system PIN
has been entered after
*PRO
when the pro-
gramming mode is started.
You can switch the system PIN on or off or change
it. In the
as-delivered state
, the system PIN is al-
ways 2580 (standard PIN), this is the middle keys
from top to bottom. The standard PIN is switched
off.
You can enter your own new PIN for better secu-
rity.
The standard PIN or the new system PIN must be
switched on and off separately.
If you forget your own system PIN you cannot do
any more programming. In this case you will have
to consult your dealer. Only he can reset the PIN.
Box PIN
– You can dial the switch box of your tel-
ecommunications system en route from any tel-
ephone, e.g. to switch over the day/night service or
set a diversion. You can protect the switch box
against unauthorised access with the 4-digit box
PIN. No box PIN is programmed in the
as-delivered
state
. You have to enter a box PIN if you want to
use the switch box.
A
E
S
N
Selection
Pz
PRO
Start programming mode:
h
*PRO
q
ª
(system PIN)
Continue programming or exit programming mode:
h
*END
q
ª
END
Off
On
S
tandard PIN
Enter
n
ew pin
Summary of Contents for AC 14 analog
Page 1: ...AC 14 communication with Operating Manual ISDN PBX a system...
Page 2: ...I 2 Introduction...
Page 12: ...S 6 Set up...
Page 67: ...K 5 Key words K...