AGCO RoGator 1100, Installation Manual

Page: 41 / 46

APPENDIX
B
P/N 016-0171-588 Rev. D 37
APPENDIX B
CONNECTING SIDEKICK PRO
ICD DIRECT INJECTION PUMPS
TO ISOBUS
CONNECTING SIDEKICK PRO ICD DIRECT INJECTION PUMPS TO THE
ISOBUS FOR REV C AND EARLIER 115-7303-085 CABLES
Sidekick Pro direct injection pumps installed by AGCO are Raven CAN version and are connected to the CANbus.
To work with the Hawkeye™ Product Control System, change the pumps to Sidekick Pro ICD pumps and connect
them to the machine’s ISOBUS using a Raven adapter cable (P/N 115-0172-325 Rev B). Contact a local Raven dealer
to order this cable and ICD pumps if necessary.
NOTE: If adding a new injection system to the machine, also order the required AGCO cable harness from
your local AGCO dealer.
1. Inspect the Sidekick Pro label to determine if it is the ICD version. The label will either read Raven Sidekick Pro™
ICD and the part number will be one of the following:
•
P/N: 1-063-0173-768 (1-40 oz/min pump)
•
P/N: 1-063-0173-769 (5-200 oz/min pump)
FIGURE 1. Raven Sidekick Pro ICD Label
2. Remove the cover of the electrical box that contains the product control ECU’s on the middle of the right frame
rail.
3. Locate the RoGator ISOBUS Tee Cable (P/N 115-0172-325 Rev B). This may have been provided with your
Hawkeye system kit, or it may need to be ordered.
4. Remove the 4-Pin to 3-Pin Deutsch adapter cable with ISOBUS Terminator and set aside. This will be used in a
later step.
5. Follow the cable from the injection pumps down the frame rail to the round bulkhead connector on the back of
the electrical box. This is typically the bulkhead connector furthest towards the front of the machine on the
electrical box.
6. Locate the mating bulkhead connector on the inside of the electrical box.