AGCO RoGator 1100, Installation Manual

Page: 24 / 46

C
HAPTER
5
20 AGCO RoGator RG900/1100/1300 Hawkeye™ Installation Manual
FIGURE 2. Node Mounting Plate Modifications
3. Remove the bolts securing the boom/speed node and product node to the mounting plate.
NOTE: Do not disconnect the nodes from cable connections at this time.
4. Use a socket and socket extension to loosen the bolt securing the node mounting plate and remove the plate
from the electrical box.
NOTE: The mounting plate will be modified to mount the Product Controller II ECU and ISO Boom/Speed
ECU in the Mounting Plate Preparation and ECU Installation section on page 21.
5. Remove the Raven AccuBoom node from the machine electrical box.
6. Tuck the two rectangular node plugs connected to the AccuBoom out of the way at the bottom of the electrical
box. These rectangular node plugs are not needed for the Hawkeye system.
7. Locate the two brown connections (four separate harness connectors) labeled “AccuBoom Tee” in the electrical
box. These are typically located in the area below the removed mounting plate.
8. Adjust the harnesses to allow access to these connectors for use during the procedure outlined in the Section
Valve Cable Connections section on page 27.
9. Use a 1-1/2” hole saw to drill a hole through the back of the electrical box in a location where the Hawkeye
system will not interfere with the existing electrical components (refer to Figure 3 on page 21).
NOTE: Be careful not to damage any existing electrical components while drilling. This hole will be used later
to connect the chassis cable to the electrical box cabling for final system connections.
Boom/Speed
Sense Node
Raven AccuBoom
Node
Raven Single
Product Node