AGCO Glencoe DCS3000, Operator'S Manual & Installation Instructions, Page: 8 / 36

OPERATION
SWITCH FUNCTIONS
Depth Control System On
Press and release touch-pad switch to energize
automatic DCS function.
LED lights when function is on.
Depth Control System Off
Press and release touch-pad switch to de-energize
automatic DCS function.
All LED’s are off.
Lower to Depth
Press and release touch-pad switch to lower
implement to pre-determined depth. LED flashes
until implement is lowered, then is steady.
Raise to Transport
Press and release touch-pad switch to raise
implement to transport position. LED flashes until
implement is fully raised, then is steady.
Manual Raise, Lower
Press and hold either end of large rocker switch to
raise or lower implement to desired height. When
switch is released, raising or lowering stops.
Note: Manual switch overrides and disengages
Automatic Mode. After using manual switch, press
and release Depth Control ON to return to automatic
mode.
Working Depth Selector
Turn rotary selector switch to set desired tillage
depth, with “A” as the shallowest setting and “N” the
deepest setting.
Note: Because of equipment variations, letters do
not indicate specific depths. Scale from “A” to “N” is
for relative positioning only.
IMPORTANT! Do not use this switch to routinely
raise and lower implement during field operation.
Hydraulic System Switch
-Press two-position rocker switch so red end
shows if tractor hydraulic system is open-center
or certain pressure-compensated types.
-Press switch so red end does not show if tractor
hydraulic system is closed-center type or other
pressure-compensated types.
Operating Notes:
a. For implement to operate with DCS, tractor
hydraulic remote lever must be in detent
position.
b. With DCS installed, tractor valve cannot be
used to raise and lower implement.
4
Fig. 4 - Control Monitor Switches and LED’s
1. Light Emitting Diodes 2. Rocker Switch
1
2
DCS-1A