AGCO Glencoe DCS3000, Operator'S Manual & Installation Instructions, Page: 20 / 36

INSTALLATION
DURING IMPLEMENT SETUP
1. Review these instructions and appropriate
diagram on following pages before installing
basic implement hydraulic system.
Note: Callouts in diagrams are for additional
parts and hoses supplied in bundle. Parts and
hoses without callouts are with base implement.
2. Install basic system and DCS system at same
time.
Note: To save time later, attach cylinder base
ends only to implement. Attach rod ends after
hydraulic system is charged and purged of air
(p. 25).
AFTER IMPLEMENT SETUP
Use the instructions and diagram on the following
pages for the appropriate implement.
HYDRAULIC CONNECTIONS
Rigid Models - CC4450 (Fig. 20)
1. With valve block securely mounted on frame,
install four fittings in valve block.
2. Disconnect existing hose from base end of
cylinder and reconnect to Port T1.
3. Disconnect existing hose from rod end of
cylinder and reconnect to Port T2.
4. Using both 3/8” x 48” hoses from bundle:
- Connect Port A to base end of cylinder.
- Connect Port B to rod end of cylinder.
5. Ensure all fittings are tight.
6. Use plastic ties to secure hoses away from
moving parts.
Folding Wing Models - CC4450 (Fig. 21)
Note: Folding wing models require Hose Bundle
#4450710, consisting of one 228” and one 270”
hose. Main bundle contains one 48” hose.
1. With valve block securely mounted on frame,
install four fittings in valve block ports.
2. Disconnect existing hose (originally at 7, Fig.
21) from rod end of RH cylinder and discard.
Replace with:
- 270” hose between cylinder and Port B
- 228” hose from Port T2 to tractor
3. Install 48” hose between Port A and base end of
center cylinder.
4. Connect existing hose from tractor to Port T1.
5. Ensure all fittings are tight.
6. Use plastic ties to secure hoses away from
moving parts.
16
Fig. 18 - Front of Valve Block
1. Solenoid Ports A, B, T1, T2
2. Optional Solenoid
Fig. 19 - Valve Block Schematic
Coil A - Lower Solenoid
Coil B - Raise Solenoid
Coil O - Open-Center Solenoid Ports: A, B, T1, T2
DCS-3A
1
T1
T2
B
A
2