AGCO Glencoe DCS3000, Operator'S Manual & Installation Instructions, Page: 14 / 36

INSTALLATION
INTRODUCTION
These instructions are for installing the DCS3000
Depth Control System on the following Glencoe®
tillage implements:
UM4650
FC3500 CC4450
UM6000 FC3550
FC3600 DR8600
SF4500
SF4600 SS7400
Note: “Secondary Tillage” denotes Unimulchers
(UM), Soil Finishers (SF), and Field Cultivators (FC).
Remaining implements (CC, DR, SS) are considered
“Primary Tillage”.
The Depth Control System (DCS) works the same
on all Glencoe® implements and uses the same
basic components, some with only minor
differences:
- Depth sensor assembly
- Actuator arm
- Control valve block
- Monitor
- Wire harnesses
Mounting bracket and actuator differences are
required for various models, but otherwise the
installation procedures are the same.
PLEASE REVIEW ENTIRE ASSEMBLY
PROCEDURE BEFORE BEGINNING
INSTALLATION.
DEPTH POSITION SENSOR
Either a plain rod-type (Fig. 1) or roller-type (Fig. 2)
crank is used for the sensor mechanism. For either
crank:
1. Insert crank in u-bracket and secure in place
with 3/8” washers and retaining rings (Fig. 1).
2. With electrical connector facing upward, attach
sensor and spacer block to u-bracket with
#10-24 x 2” machine screws, lock washers, flat
washers, and nuts (Fig. 1).
- Engage tang on sensor shaft with crank slot.
- Center the screws in adjustment slots.
Note: Sensor shaft is internally spring-loaded. Orient
crank arm as shown so spring pressure is applied as
crank is raised.
IMPORTANT! To prevent sensor damage, do not
force shaft to rotate beyond internal stops.
3. Rotate crank from one stop to the other. If binding
occurs, loosen and realign spacer and sensor.
4. Roller-type crank: Install roller, washer and
retaining ring (Fig. 2).
10
Fig. 1 Sensor Assembly with Plain Crank
1. Crank 2. Washer 3. Retaining Rings
4. Switch 5. U-Bracket 6. Spacer
Fig. 2 Sensor Assembly with Roller Crank
1. Roller 2. Washer 3. Retaining Ring
DCS-5A
DCS-6A
1
2
3
1
2
3
4
5
6