Cotton Picker Installation
Ag Leader Technology
CaseIH 2055
November 2002
2006200-1
9-10
Figure 10. GPS bulkhead connector installed.
2. Position the 10-ft coax so the right angle connector attaches to the monitor and
the other end attaches to the bulkhead connector. Attach 10-ft coax cable.
Route the coax with the cab cable. Fasten with cable ties of secure.
3. Any excess cable should be looped and tied at the back of the cab just above
the bulkhead connector.
4. Route the 15-ft coax cable from the bulkhead connector to the antenna located
on the front center of the cab.
5. Use cable ties and adhesive backed anchors to secure the coax cable to the cab.
6. Replace the interior and exterior access panels.
Bulkhead
Connector
