AFM LX-150, User Manual

Page: 184 / 246

184 Troubleshooting
4510001 REV B – 220620
Problem Possible Cause Solution
Labels are being cut too
short, too long, or in the
wrong place
The Print-Reading Sensor is too
high or too low, and/or the Print
Reg Dwell setting is incorrect.
Adjust the height of the Print-Reading
Sensor and/or the Print Reg Dwell
setting (see “Fine-Positioning the Film
for Cutting” on page 128 and the last
step of “Loading a Recipe” on page
135 ).
Wrong recipe is being used. Check that the correct recipe is
loaded, and if needed, load the
correct recipe (see “Loading a
Recipe” on page 135 ).
The Film Drive Wheels are not
tight enough against the Film
Drive Bearings (slipping and
preventing them from advancing
the film with precision)
Adjust the Film Drive Wheels (see
“Film Drive Wheels:
Unlocking/Adjusting/Locking” on page
112 ).
The Print-Reading Sensor Lens
is dirty or dusty.
Clean the Print-Reading Sensor Lens
(see “Cleaning the Print Reading
Sensor” on page 150 ).
The Cut Length or some other
part of the recipe is incorrect.
Reevaluate the recipe settings (see
“Fine-Positioning the Film for Cutting”
on page 128 and “Loading a Recipe”
on page 135 ).
The Print-Reading Sensor’s
sensitivity needs to be adjusted.
Adjust the Print-Reading Sensor’s
sensitivity (see “Checking and
Adjusting the Print Reading Sensor’s
Sensitivity” on page 179 ).