5
Note: U
se “Painter’s Tape” to apply a protective guard around the work areas (fender and
Front bumper fascia). This will help protect the paint and finish of your vehicle.
Note: It may be easier to remove the tire and the wheel well from the truck.
5.
Remove the four (4) screws from the front of the wheel well on both sides of the vehicle.
6.
Carefully pull the wheel well down far enough to expose the back side of the bumper and
the inside of the fenders.
Summary of Contents for 79-21007L
Page 3: ...2 ...
Page 14: ...13 15 Remove and discard the two 2 nuts from the supplied 20 single row LED light ...
Page 23: ...22 28 Reinstall the twelve 12 screws into the core support removed in Step 4 and tighten ...
Page 25: ...24 32 Remove all the painter s tape if any was applied 33 Installation is now complete ...