14
Note: Please read the instruction below prior to installation.
16.
Locate the drilled hole furthest to
the driver’s side.
Install one (1) supplied #10-
32 x 1/2”
button head screw (black) thru the front of the aFe Scorpion grille. Turn the aFe Scorpion
grille over and install the aFe logo back plate onto the #10-
32 x 1/2” button head screw
(black). Install one (1) supplied #10-32 SS flange nut onto the #10-
32 x 1/2” button head
screw (black). Snug the #10-32 flange nut up but do not tighten.
17.
Install the supplied
20” single row LED light through the front of the aFe Scorpion
grille.
While holding the 20” single row LED light
, install two (2) supplied #1 LED bar brackets
(bracket feet point away from each other) from the back of the aFe Scorpion grille and onto
the
studs on the 20” single row LED light. Install the two (2)
supplied 1/4" washers (black)
and two (2) supplied 1/4"-20 nylon lock nuts (black) onto the light. Do not tighten. From the
front, install four (4) #10-
32 x 1/2” button head screws (black) through
the aFe Scorpion
grille. Turn the aFe Scorpion grille around
and make sure that the driver’s side
#10-
32 x 1/2”
button head screws (black) pass thru the aFe logo back plate and thru the #1 LED bracket.
The passenger side runs thru the #1 LED bracket only. Install four (4) #10-32 SS flange nut
onto the #10-
32 x 1/2” button head screws (black). Tighten the #1 LED brackets first. Then
tighten the 20” single row LED
light while centering it.
Summary of Contents for 79-21007L
Page 3: ...2 ...
Page 14: ...13 15 Remove and discard the two 2 nuts from the supplied 20 single row LED light ...
Page 23: ...22 28 Reinstall the twelve 12 screws into the core support removed in Step 4 and tighten ...
Page 25: ...24 32 Remove all the painter s tape if any was applied 33 Installation is now complete ...