Albert 2 User Manual
February 2018| ©AEVI International GmbH
PAGE 22/46
•
If you remove the device from the charging cradle the “battery charging” icon on the system
bar changes to the icon showing battery life. In addition the screen is automatically switched
on as soon as the device is being removed.
•
If the battery charge goes down to 1-2%, the Albert 2 automatically switches itself off.
•
If the battery charge is below 10%, the Albert 2 plays a sound and a warning message appears
on the screen that indicates Albert 2 has to be put back on the cradle.
When the device is OFF:
•
If you put Albert 2 onto the cradle, the LED in front of the cradle goes ON and the device
starts charging (but remains OFF)
•
If you disconnect it from cradle, the LED goes OFF and the device stops charging (and remains
OFF).
•
You can switch the Albert 2 ON by pressing and holding down the power button for about 4
seconds, until the white camera LED and the red tamper LED is flickering for one second.
When the device is SUSPENDED:
•
If you put it onto the cradle the “battery charging” icon is displayed on the system bar and the
charging cradle LED is shining.
•
If you disconnect it from the cradle charging stops and it wakes up. It might prompt you for a
password depending on configuration.
•
Wake it up by pressing the power button once. You might be prompted to provide a password
(after which the device shows the screen that was being displayed prior to its going to
SUSPEND)
7.2
First Time Power Up
Before starting the system, charge the battery pack for at least three hours.
•
Insert the DC jack of the power pack into the payment
