Mirage Digital Evolution
AEV Broadcast Srl via della Tecnica 33, 40050 Argelato Bologna ITALY
www.aev.eu [email protected]
22
This control allows you to work MIRAGE DIG EVO as a dynamic expander; the concept can be explained
by an example:
Suppose we work under these conditions:
LEVEL SINGLE BAND SIGNAL -10 dBm
GAIN 0 dB
THR LIMITER 0 dB
The input level is lower than the compression threshold so it is not limited but at the same time it has
an amplitude of
- 10 dBm which determines a low output signal.
5.4
Page COMPARATE
ON AIR: Displays the process in transmission.
PRESET: Select the process to send in transmission.
COMPRESSOR. Process activated or bypassed
"
ESC
" to exit without store the modifications; the "
SAVE
" to save and store the modifications
On this page you can see the active output curve outbound, select an alternate curve, perform the
comparison of the output audio effect between different processes, then decide which curve to make
active
•
ON AIR
When the mask is opened, at the ON AIR line, the active wave curve will be displayed,
positioning the cursor on this item and pressing the knob will activate the selection of available curves
when you have selected the desired curve , Pressing the knob turns on the wave curve.
•
PRESET
Rotating the knob position the cursor in the PRESET item.
By positioning the cursor on this item, and by pressing the knob, you can select one of the available
curves on the selected curve and select it as an alternative curve by pressing the knob. Select the
process to send in transmission.
