Mirage Digital Evolution
AEV Broadcast Srl via della Tecnica 33, 40050 Argelato Bologna ITALY
www.aev.eu [email protected]
15
4.2.5
Page INPUT SETUP
In this form you set some functions that determine the management of the input audio signal.
The following items are sequentially:
•
INPUT MAIN
: Selects the active input, named
MAIN
. Place the cursor on the box, the knob
is pressed to select the input channel that will have the first priority of use between the three
available inputs (ANALOG, DIGITAL AES/EBU and DIGITAL OPTICAL), the next knob pressure on
the entry Chosen determines the storage of the choice made
•
ANALOG IMP
. Setting the impedance value of the analog input signal. Possible values are
600 Ohms or 10K Ohms. By placing the cursor on the box, you activate the value change with
the knob pressure, after selecting the desired impedance value, the additional pressure sets the
value indicated in the box.
•
INPUT MODE
. Setting the input signal mode. The possible selections are:
L R ON
,
L ON, R
OFF
,
L OFF
.
•
L R ON
: The two input channels will have distinct paths and processes.
•
L OFF
only enables the signal on the right channel,
•
R OFF
only enables the signal on the left channel.
The two selections
L OFF
and
R OFF
are used to check the consistency of the Left and Right
channels in case of link transfers or other transfer modes before the signal input in the
transmitter. By placing the cursor on the box, you activate the mode change by pressing the
knob, after selecting the desired mode, the additional pressure sets the value shown in the box.
To save the changes to the values in this form, position the cursor on the
SAVE
button and
press the Jog knob once, at the knob pressure you save the changes and return to the MENU’
To exit the mask, position the cursor on the
ESC
button and press the jog knob to return to the
MENU screen when the knob is pressed.
