Aethra vega X5, User Manual

Page: 72 / 108

72
NIC network interface (option)
This interface can be used by means of the “XLNA” external module
(see “X LINE NETWORK ADAPTER” §).
G.703 interface configuration (option whit license)
In order to use G.703, it is necessary to have a licence (see section on licensing for
more information).
In this menu you can:
Choose either the
E1
or
T1
protocol
If the system has already been configured to support a PRI interface (either
Euro or National), the E1/T1 option is not available and the system is
automatically set to the appropriate mode:
Euro Primary Access G.703 E1;
National Primary Access G.703 T1.
Choose the
Rate
.
Set the Network speed ( 64K or 56K ).
Enable/Disable
Automatic call
.
To make an automatic call:
1. Enter Audio-Video call page.
2. Select NIC in Type of call drop-down menu.
3. Wait for few seconds, and the System will automatically start the call.
Enable/Disable
Use Ch16
.
Enable/Disable
CRC4
(E1 only).
Enable/Disable the Enabled Alarms option.
Configure the System to be either
Master
or
Slave
in calls.
G.703 advanced
settings (T1 only).
Select Cable length, from the drop-down menu, you can select the length of
the G.703 cable.
Note:
If the system is configured with PRI lines, Euro or National, the System automatically
selects the net in the following way:
Primary Rate Euro Access
→
G.703 E1;
Primary Rate National Access
→
G.703 T1.
Note:
If “Automatic call” option is enabled, System will start the call as soon as it notices the
presence of a line.