Aethra vega X5, User Manual

Page: 19 / 108

19
System positioning and installation
!
All operations must be carried out without connection to main power supply.
Connection to main power supply should only be performed after complete parts
assembly.
Place the System in the desired location, and connect the follow equipments:
1. Connect the “Aethra High Band POD”
(see “Cabling Scheme”, cable
1
).
2. Connect:
“
LINE OUTPUT
” audio outputs to audio inputs of main monitor or to an amplifier,
“
VGA
/
DVI
-
I
” system main video output to main monitor input,
(see “Cabling Scheme”, cable
2
).
3. Connect the LAN input to the network.
(see “Cabling Scheme”, cable
3
).
4. Connect the ISDN inputs to the network terminations.
(see “Cabling Scheme”, cable
4
).
!
Connect the ISDN input (ISDN connector or network interface) only to a
network termination (NT1). Do not connect the equipment to an external
telecommunications line.
5. Connect supplementary audio or video equipments to the available inputs/outputs.
6. Connect the power supply.
(see “Cabling Scheme”, cable
5
).
7. Switch the monitor ON.
8. Press the switch on key on the System rear.
The system status LED on the front means:
•
LED on : System is on and normally operating.
•
LED flashing : System power is on, but the System is in “standby” mode.
•
LED off : System power is either off or not connected.
9. Wait for the main user interface to appear.
“MODE” connector
Using the MODE connector you can preset the auxiliary monitor directly on the SCART
input.