15
USA
►
Reset motor settings to default settings
– Press button “Factory reset”
a
.
– Confirm message.
Drill tool GA844
The settings below are additionally available for the drill tool GA844:
6.4.3
Device settings
Fig. 12 Device settings
Legend
a
Exit menu
b
Set system volume
c
Setting display brightness
d
Reset system volume and brightness to default settings
e
Set system language
f
Reduce value
g
Increase value
►
Exit menu: Press Exit menu
a
button.
►
Change system volume/brightness: Press button “Increase value”
g
or
“Reduce value”
f
.
The change is implemented immediately. The set value is displayed.
►
Set system language:
– Press button “language”
e
.
– Select desired language.
►
Reset system volume and brightness to default settings
– Press button “factory reset”
a
.
– Confirm message.
6.4.4
Wireless foot c1ontrol
The wireless foot control GA810 can be connected to the control unit or
disconnected from the control unit via the menu “radio footcontrol”.
Fig. 13 Wireless foot control settings
Legend
a
Connect wireless foot control (or disconnect if a wireless foot control
is connected)
►
Connect the GA810 wireless foot control:
– Select Connect to GA810 button and
– follow the instructions on the display. Compare the serial number
in the control unit display to the
– serial number of the wireless foot control and select "Yes" to con-
firm the message.
►
Disconnect the GA810 wireless foot control
– by pressing the “Disconnecting from GA810” button
– or –
– switch off the control unit for approx. 10 min.
6.4.5
Device information
The “device information” menu displays general information about the
device and the device software.
►
Leave the menu: Activate the “Leave menu”
e
button.
7.
Reprocessing procedure
7.1
General safety notes
Note
Adhere to national statutory regulations, national and international stan-
dards and directives, and local, clinical hygiene instructions for reprocess-
ing.
Note
For patients with Creutzfeldt-Jakob disease (CJD), suspected CJD, or possi-
ble variants of CJD, observe the relevant national regulations concerning
the reprocessing of products.
Note
It should be noted that successful reprocessing of this medical device can
only be guaranteed following prior validation of the reprocessing method.
The operator/reprocessing technician is responsible for this.
Setting
Description
Oscillation mode
Determines whether the oscillation function
on the drill can be activated.
Oscillation angle
Total oscillation angle
Thread cutting operation
angle left
Thread cutting operation angle counter-
clockwise
Thread cutting operation
angle right
Thread cutting operation angle clockwise
a
b
c
d
e
f
g
a
Document No.: IFU - Version: 3.0 - Document ID: SOP-AIC-5001568 Date/Time Printed/Viewed: 2022-04-13 15:59 (CET)
Effective