11
There are two ways to remove collected water: Manual Drainage or Automatic Drainage
MANUAL DRAINAGE
• When the water bucket is full, the FULL BUCKET indicator light will
flash and the unit will beep for
10 seconds
• Slowly pull the bucket out of the unit (see image)
• Carefully remove the top of the water bucket and dispose water
• Replace the top of the water bucket and slide back into the unit
NOTE:
The water bucket must be securely reinstalled for the unit to operate. Make sure the
lid is firmly fastened and the floating ball is able to move. It is recommended to turn
off and wait several minutes for residual condensate and fully drain into the bucket.
WATER REMOVAL
WARNING: To avoid electric shock, disconnect power before removing collected water.
!
AUTOMATIC DRAINAGE
Water can automatically be emptied into a floor drain by connecting the included Drainage
Hose.
NOTE:
This option will require the unit to drain via a gravity system. Failure to properly
place the unit and install the hose may result in water leakage. Please read
instructions thoroughly. Once installed, we recommend monitoring the Pure & Dry
unit to ensure the unit is draining properly.
Step One:
Find the drainage port on the side of the
dehumidifier, as shown in the figure.
Step Two:
Insert a screwdriver into the circular
groove, pry off the ribs connected
with the body, and take out carefully.
Up
Before
After
Drainage Hose Connected
Pry Up
Summary of Contents for Pure & Dry
Page 19: ...19...
