english
AVT conTrol pAnel
(on CLASSIC TC central power units)
AVT PANEL
The central power unit is equipped with an AVT panel
(timed display) that makes it possible to display the
central power unit's main maintenance operations.
DUST CONTAINER FILLING LED
Indicates the presumed maximum filling of
the dust container.
When the LED turns on, the dust container is full and
must be emptied.
Perform the maintenance and turn off the signal by
pressing the PRESS RESET button.
FILTER CARTRIDGE SATURATION LED
Indicates the presumed maximum saturation
of the filter cartridge.
When the warning light turns on, the filter cartridge is
saturated and must be regenerated or replaced.
Perform the maintenance and turn off the signal by
pressing the PRESS RESET button.
MOTOR TEMPERATURE LED
This indicates a central power unit lock due to
a motor chamber temperature that exceeds 80°C.
To reset central power unit use, the temperature must
go below 55°C.
After the temperature has gone below 55°C, press the
PRESS RESET button to remove the signal
LED ON
This indicates normal central power unit operation.
LED ON BLINKING
Indicates that the operating vacuum exceeds the value
of 240 mbar. The central power unit will be locked after
15 seconds.
CONTROL PANEL OPERATION
LED STAND BY
This indicates that the central power unit is
powered but not being used.
PRESS RESET BUTTON
This is used to reset central power unit anomalies
HIGH OPERATING VACUUM LOCK
The central power unit is locked because the operating
vacuum exceeded the 240 mbar limit for more than 15
seconds;
The ON and PRESS RESET lights blink ( see LOCK TABLE
of the TC central power units)
Switch off the signal by pressing the PRESS RESET
button.
Installation
Installation
19
