18
Stab/Elevator Installation
1. Slide the horizontal stabilizer into the pre-cut
slot in the fuse. Use a ruler to center the stab
from the back like shown below.
3. Ensure the ailerons are centered with the wing, it
may be necessary to tape them in place. Adjust
the stab so it is centered left to right in the fuse
and is pushed all the way forward. Measure from
the wingtips to the corner of each side of the
stab, adjust the stab until these distances are
equal. This ensures the stab is square with the
wing.
2. Install the wing and check the alignment of the
stab to the wing.
4. Use medium size binder clips to help hold the
stab in place once the correct position is found.
Note :
Take care not to crush or damage the
stabilizer with the binder clips.
