11
Aileron Servo Installation
1. The ailerons have been pre-hinged and
glued
to
the wing panels and are ready for flight. No
other steps are necessary for hinging. Clear
Covering is supplied for sealing the hinge gaps if
desired. However, due to the precisely aligned
and minimal hinge gap this step is optional.
Gather one wing panel, two aileron servos, one 11”
Y harnesses, and one 24” servo extension as
shown below to begin the servo installation.
Note:
A 6” extension will also be needed per wing
when connecting aileron servos to receiver.
WING ASSEMBLY
2. Layout the servos, extensions and Y harness on
the wing to test fit the installation and ensure
servo leads are the correct length.
Minimum recommended servo:
180 in. oz. / Metal Geared / Digital
3. Attach the 24” extension to the outboard servo
lead and secure with an Aeroworks safety clip.
Ensure the connectors will not come apart from
vibration or light tension.
IMPORTANT
1.
If hinges will not go to the full deflection it may
be necessary to apply heat using a heat gun
while holding the surface at its full deflection.
This will allow the hinges to move freely.
