42
11. Solder the threaded coupler to the throttle
pushrod wire.
Note:
Lightly sand end of rod for best bond.
12. Finished pushrod shown below.
13. Attach the throttle pushrod with the 4/40 ball
links and secure. Power up the receiver and
throttle servo and adjust pushrod for proper op-
eration. Ensure the servo or rod does not bind or
jam at closed or full open positions.
1. A none soldering method of attaching throttle
pushrod is shown in the following steps.
Hardware for this method is
not supplied
.
Gather (2) 4-40 ball links, (1) brass spacer,
and 4-40 all thread.
