5. Attach the adhesive back strip of Velcro pile to
the bottom of the battery pack as shown.
6. Insert a 6” servo extension in the aileron channel
of the receiver. The antenna may be shortened
by winding on a flat spool if desired.
7. Plug the rudder servo, elevator servo, and motor
control leads into the correct channels of the
receiver.
8. Slide the receiver antenna under the servo tray to
the aft section of the fuse. Carefully tuck the
servo wires under the servo tray and mount the
receiver to the fuse floor with double-sided foam
tape. Slide the battery onto the battery tray as far
forward as possible with the Velcro on the
bottom. Then wrap the pre-installed Velcro strap
around the battery to secure the battery pack in
the fuse. Then plug the battery into the speed
control battery connector as shown.
29
