Aerogen Aeroneb Solo, Instruction Manual

Page: 34 / 36

32 Aerogen
Guidance and manufacturer’s declaration – electromagnetic immunity for a system that
is not life supporting
This Aeroneb Solo nebulizer system is intended for use in the electromagnetic environment
specified below. The customer or the user of the Aeroneb Solo nebulizer system should assure
that it is used in such an environment.
Immunity Test
IEC/EN 60601
Test Level Compliance
Level Electromagnetic
Environment - Guidance
Conducted RF
IEC/EN 61000-
4-6
Radiated RF
IEC/EN 61000-
4-3
3 Vrms
150 kHz to 80
MHz
3 V/m
80 MHz to 2.5
GHz
3 Vrms
3 V/m
Portable and mobile RF communications
equipment should be used no closer to
any part of the USB Controller System,
including cables, than the recommended
separation distance calculated from the
equation applicable to the frequency of the
transmitter.
Recommended Separation Distance
d = [1.17] √P
d = [1.17] √P... 80MHz to 800MHz
d = [2.33] √P... 800MHz to 2.5GHz
where P is the maximum output power
rating of the transmitter in Watts (W)
according to the transmitter manufacturer
and d is the recommended separation
distance in metres (m).
Field strengths from fixed RF transmitters,
as determined by an electromagnetic site
survey,ª should be less than the compliance
level in each frequency range.
b
Interference may occur in the vicinity of
equipment marked with the following
symbol:
Note 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
Note 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
a) Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios,
amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess
the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be considered. If the
measured field strength in the location in which the USB Controller System is used exceeds the applicable RF compliance
level above, the USB Controller System should be observed to verify normal operation. If abnormal performance is observed,
additional measures may be necessary, such as re-orientating or relocating the USB Controller System.
b) Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3V/m