Aeroflex SmartStep 8310, Operation & Installation Manual

Page: 3 / 85

CAUTION
•
All procedures and/or steps identified as
must be followed exactly as written and
according to industry accepted ESDS device
handling procedures. Failure to comply WILL
RESULT in ESDS damage.
•
DO NOT use a nylon bristle brush in the solvent
as the bristles may dissolve and cause damage to
the circuit card or component.
•
DO NOT use ultrasonic cleaning on parts or
assemblies containing electrical or electronic
components.
•
DO NOT bend pins of electrical connectors
when using fiber-bristle brush.
•
Compressed air used for cleaning and/or drying
can create airborne particles that may enter the
eye. Goggles/faceshields should be worn. DO
NOT direct air stream towards self or other
personnel. Pressure should be restricted to a
maximum of 15 psi to avoid personal injury.
•
Under no circumstances should a wire brush, steel
wool, or abrasive compound be used on any
surface. Using these items will cause extensive
damage to the instruments surface.
NOTE
DO NOT return any instrument or component to
Weinschel Corporation without receiving prior
factory authorization.
SAFETY SYMBOLS.
The following symbols are used to identify safety hazards
found throughout this publication and/or located on the
instrument.
WARNING
HIGH
VOLTAGE
CAUTION
HIGH VOLTAGE
SAFETY SUMMARY
ii