aero-naut Quido, Assembly

Page: 6 / 24

Trim off spars and sheeting material at end ribs and
position wing tips 39 at end ribs (do not glue!). Cut
leading edge parts 28 to correct angle and length
and glue to front of ribs. Glue in place plywood
gussets 45 and upper trailing edge sheeting 38.
7
Remove outer wing panels from jigs, cut off
tabs and carefully sand underside of wing
tips. Glue wing tips 39 to outer wing panels
and glue in place balsa triangles 46 which
support the wing tips.
8
Trim off upper trailing edge sheeting
material, then sand leading edges and
wing tips to shape.
9
Ribs with a triangular cross-section are used for
correct dihedral of outer wing panels. Glue one
rib 40 each flush with underside of wing panels
to centre wing panel and to wing tips. Carefully
sand outline of ribs to shape after glue has
dried.
10
39
28
45
38
46
40