Quido
is a small model that accompanies you wherever you go. The prefabricated parts are mostly balsa and just need to be assembled according to
the step-by-step building instructions.
With the exception of the tail end of the fuselage, which is a carbon tube, and spruce spars Quido is a pure balsa model. The result is a light-weight yet
strong model. A 2S-LiPo and an outrunner with 100 to 150 Watts are recommended to power the Quido. In addtion you´ll need basic 3-channel radio
equipment with two micro servos and a speed controller.
Construction should be according to the step-by-step instructions provided in this manual. All parts can be identified by means of the parts list at the end of
the manual. Always check that parts fit perfectly. Correct, if necessary, before you glue. Give glue sufficient time to dry before you continue with the next
step.
We recommend white glue (if not otherwise noted) for gluing, which offers good strength and low weight. White glue retains a certain degree of elasticity
even after the glue has cured and will stand up to any loads which occur during flying.
Technical Data
Wing span:
1,070 mm
Length:
850 mm
Weight:
from 450 g
Wing area:
21.3 dm²
Wing loading:
from 21 g/dm²
RC-functions:
rudder, elevator, motor control
Required equipment
Ÿ
Outrunner with backplate mount and approx. 150 W
Ÿ
20 A ESC
Ÿ
2 micro servos, 23×12 mm
Ÿ
2S-LiPo, 850 mAh
Ÿ
collet prop adaptor (3.2 mm shaft)*
Order.-No. 7124/08
Ÿ
collet prop adaptor (4.0 mm shaft)*
Order-No. 7124/11
Ÿ
aluminum yoke 38 mm
Order-No. 7242/21
Ÿ
CAM Carbon folding prop 8×4“*
Order-No. 7234/13
* Compare recommendations with data sheet of motor
We recommend oour aero-pick
modeller´s pins for building.
Order.-No. 7855/02
Tip
The wing spar is a lamination of three spruce spars.
Mark the centre on all three spars and glue spars
together as shown. Secure spars with tape or clamps
until glue has dried completely. Remove any residual
glue and carefully sand surface of spar.
1
Sort ribs according to cross-section of spar and slide
ribs on spar. Do not glue!
Attention:
Make sure to place the two centre ribs
29 in the correct position as they will be sheeted
later on!
2
22
24
23
29
30
31
32
Summary of Contents for Quido
Page 1: ...aero naut Order No 1303 00 Electric Model Aeroplane Quido...
Page 23: ......
