aero-naut Quido, Assembly

Page: 5 / 24

Place spar with ribs on Depron jig and glue ribs to spar. Glue in place upper
wing spars 25 and lower trailing edge sheeting 37.
3
Glue leading edge 27 to the front of ribs and glue in place
balsa gussets: glue front gussets to groove in leading edge
and rear gussets to top of trailing edge sheeting. Glue the
longer gussets 43 to centre ribs and the short gussets 44 to
the outer ribs. Also glue in place upper trailing edge sheeting
37. Cut to length upper centre wing sheeting 36 and glue in
place.
4
Remove centre wing panel from jig and
turn upside down. Cut off tabs with
modeller´s knife or razor saw and glue in
place lower centre wing sheeting 36.
5
Build up the outer wing panels. Insert
ribs 33 to 35 into wing jigs and glue
in place spars 26 and lower trailing
edge sheeting 38.
The sheeting material is a bit oversize
and will be cut off later.
6
25
37
37
27
43
44
36
36
38
26
33
35
34