A
E
R
A
A
I
R
I
N
N
O
V
A
T
I
O
N
9
Air handling units can wait for the time of assembly at construction sites or warehouses. In such storage situations, the
warnings below should be taken into account.
•
In order to avoid pollution, all gaps in the air handling unit must be covered. If stored in a wet environment, sufficient
ventilation should be provided. Store components of air handling units in a dry and non-condensing place.
•
Ensure that the air temperature is between -10 ° C and 40 ° C and the storage area is away from water.
•
Nothing must be placed on the units. The units must not be walked on, and the materials that may damage the
units must not stand on the units.
•
Protruding parts of the units, such as coil connections and dampers etc, must be protected from damage.
•
The product will be out of warranty if it is not stored in appropriate environments and conditions.
3. Assembly
Before starting the installation, the checklist in chapter 4 must be checked!
3.1 Assembly Area
Errors that occur when installing and assembling air handling units can potentially
lead to fatal situations and cause serious physical damage. There is also a risk that the air handling unit may not function
properly.
The installation place of the unit must be flat and balanced. If the floor is not stable, the air handling unit must be
balanced with appropriate balancing elements. In the absence of suitable balancing elements, it is recommended to
prepare the floor at least 10 cm above the ground as it will protect the device from rain and floods.
As a result of assembling the air handling unit with imbalance, the air handling unit
may not function properly. In this case, damages that may occur in the unit are not covered by the warranty.
Adjustable feet can be installed under the base of the unit in order to be able to adjust the balance of the unit more
easily against planar irregularities that may occur at the installation place. Feet are supplied as accessories. If the unit is
supplied with these feet, the balance of the unit can be adjusted with the 2 nuts on the feet.
The assembling location of the unit must be in balance!
There should be enough space for the height of the siphon in the modules where the condensation pan is located.
Check the “Siphon installation” chapter for further information.
ATTENTION
ATTENTION
