12
Installation and Assembly
• If the rear of the unit is not accessible, screw the interior dividing joint connectors in the
corner together.
NOTE
An additional dividing joint connector is provided in the middle of the profile (internally)
where the internal unit width or height is 1240 mm or more – this must also be screwed
tight.
• Seal pipe and cable ducts to prevent air leakage and condensation using Polyurethane
foam, or similar insulation metarial (not included in EVO-M delivery scope).
Additional measure for double-deck/side by side units
• Connect both unit parts using the provided plates.
Additional measure for hygiene units
• Clean and seal all internal dividing joint grooves in the floor area.
The sealant is included in the scope of delivery for hygiene units.
Fig. 6-6: Internal view
Figure 6-7: Pipe duct
Figure 6-8: Connecting unit parts
Figure 6-9: Dividing joints.
