AEQ
PHOENIX MERCURY
28
•
You can monitor the status of the call on the screen:
o
CALLING.
o
CONNECTING
(depending on the communication interface and the network
status, this may be a status of extremely brief duration).
o
SYNCHRONIZING
(depending on the communication interface and the network
status, this may be a status of extremely brief duration).
o
CONNECTED.
•
Verify that the “
SYNC
“ LED beneath the “
CALL
“ button is lighted in green to indicate
that the communication has been successfully established.
•
Press the “
ON AIR
“ button to enable audio transmission in full duplex mode.
•
Once the connection has been established with the remote end, confirm the presence
of transmitted and received audio by checking the audio presence indicators “Tx” and
“Rx”.
•
If necessary, adjust the output levels in the “
att
” box at OUTPUTS block in
“Configuration”
Æ
”General” screen. You can also make an additional adjustment from
the windows you access by pressing “In gain” button in “ENCODER” green window and
“Out gain” button in “DECODER” green window.
NOTE:
In order to make calls to
multiple destinations
, please consult section 3.2.3.1 of this
manual.
4.5.1.1. Finalizing an IP communication in RTP mode.
•
To finalize the communication, simply press the “
CALL
“ button in the individual codec
control window and then confirm. Repeat the process in the unit at the other end.
4.5.2. Establishing an IP communication in PROXY SIP mode.
•
Ensure that the equipment is powered up and controlled by the software.
•
Establish the appropriate audio configuration (analog/digital input mode, gains, routing
of inputs to the codec, suitable encoding).
•
Check that there is incoming audio: the “Tx“ indicator in the individual codec control
window
, in the general configuration screen
and in the list
view
will change to green .
•
Go to general configuration screen and configure “INTERFACE” as “Net1 SIP, Proxy
based”:
•
Then the equipment tries to register in the defined SIP server (“REGISTERING”). When
the process is done correctly “REGISTERED” indication will be shown and the call can
be made; if not, “REGISTRATION_ERROR”
indication appears: in that case, you must
check the unit’s configuration as indicated in
the following steps.
•
Enter “I/F Setup“ and click on “SIP
Parameters”.