2021. 05. 04.
Setup - Smart Home Hub : Aeotec Help Desk
https://aeotec.freshdesk.com/support/solutions/articles/6000240326
5/7
3. Select "
SmartThings Hub (IM6001-V3P)
"
5. Select "
Start
"
6. Set where your Aeotec Smart Home Hub
location
is, and what
room
it will be in.
7. Then select "
Next
"
8. Select how you'd like to connect your Hub by touching
Wi-Fi
or
Ethernet/Wired.
(depends on your choices in
section c. Power up smart home hub)
9. SmartThings will ask you to power your hub if you have not done so already. Tap on
Next
.
10. If your hub isn't ready yet, your app will scan for your hub to be ready. Once its automatically detected, it will
move onto the next step.
11. Using your mobile device's camera,
scan the QR code located on the back of the Hub
:
If necessary, tap
OK
to give Smart Home Hub access to your smartphone camera.
If your having trouble scanning the QR code, tap "
Add device by serial number
" and enter the code
manually.
12. It will ask you to join a SmartThings WiFi network
(
"
st-hubv3-858")
or some other similar name, make sure you
press
Connect
. This is necessary to setup, if you tap cancel, your setup will fail and may require you to factory
reset your hub before you start again.
13.
(Skip if you are using direct Ethernet connection)
If you are setting up the Hub via
Wi-Fi:
Select your Wi-Fi network.
Enter your Wi-Fi network's password, then tap
Connect
.
14. Wait a few moments while your Hub is connecting. (During this time, the LED of your Smart Home Hub will by
cycling
red
/
green
during the setup).
1. It will register your hub first which will take about 2 minutes to finish.
2. Once registration is finished, it will begin downloading any updates necessary for your hub. This will take
upwards of 30 minutes depending on how good you internet speed it.
3. Once downloading is done, your hub will install the downloaded update, this should take up to
5 - 10
minutes
. (At this time the LED of your hub should be
blinking blue
).
Note -
in the middle of the installation, you may notice that the LED of your hub has become
solid
Green
. This is a good indication that your hub is setup, but the interface is still getting other
settings ready, but I would recommend waiting until the screen automatically finishes.
You can close down your Smartthings app, and re-open, and your hub should appear
properly in your SmartThings app the next time you open it if you did choose to.
4. When the setup is complete, it should automatically ask you to setup its geolocation.
15. Touch
Tap here to set a location
to set a geolocation for your Hub
Drag the pin to your location, or enter your address manually.
Pinch and zoom the circle to set the size of your geolocation.
Tap
Done
.
16. When the Hub is successfully added, name it however you like, then touch
Done
.
f.
Can't connect and need assistance?
Before you start troubleshooting.
If your SmartThings app freezes during the firmware update process
. Wait up to 10 minutes before you
follow the steps below:
1. Force close SmartThings app.
2. Open up SmartThings app.
