32
Simple Logger
®
II Series
4.8
Logger Operation
When the instrument is in STANDBY mode, the following occurs (provided
there is sufficient battery voltage and no data is stored in the instrument’s
memory):
•
The GREEN LED single-blinks every 5 seconds. (STANDBY
mode is active and the logger is not recording).
•
The RED LED is OFF, indicating there is no data in memory.
•
The
PRESS
button is used to Start/Stop a Recording Session.
•
If the
PRESS
button is not pressed for a period of one minute,
the instrument will enter SLEEP mode and wait for either another
button press or the recording start time to arrive (if a recording is
scheduled). While in SLEEP mode, the LEDs will not blink.
•
A button press of 0.5 second will return the unit back to the normal
STANDBY mode.
4.8.1 Recording with Memory Cleared
When a recording starts, the logger will continue to record until one of the
following occurs:
•
The session is complete.
•
The memory is full and the recording mode is Start/Stop or Alarm.
•
The
PRESS
button is pushed until the STOP (ORANGE) LED
lights up and is released before the next LED lights.
•
The Stop Recording command from the Simple Logger II Control
Panel is sent to the unit.
•
The battery voltage falls below 1.7V.
4.8.2 Recording with a Partial or Full Memory
If the RED LED is double-blinking every 5 seconds, the memory is full and
must be erased before any further recording can be performed.
If the RED LED is single-blinking every 5 seconds prior to starting a new
recording session, the memory is partially full.
To save, clear, or check memory availability, use the Simple Logger II Con
-
trol Panel software.
There may be instances where the GREEN LED is also double-blinking
every five seconds indicating that the logger is still recording. The user
can choose to stop the recording session and download the session and/
or erase the memory.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
