Simple Logger
®
II Series
29
4.3
Recording Data
The Simple Logger
®
II must first be configured before a recording can be
performed (see the DataView
®
Simple Logger II Control Panel Help).
Once a configuration is written to the instrument, the logger will no longer
need to be connected to DataView
®
to start the scheduled recording.
When data is stored in the memory, the user may download the informa
-
tion onto a hard-disk.
A scheduled recording will still start even if the logger is in sleep mode.
4.3.1 Starting a Recording Session
A new recording cannot be started if the memory is full.
1. Connect the instrument to the measurement source.
2. Make sure the logger is in
STANDBY
mode.
3. Press and hold the
PRESS
button. When the
START
(GREEN) LED
lights up, release the button.
4. The GREEN LED double-blinks every 5 seconds when the logger is
recording.
It may take a few seconds before the instrument starts recording. The
recording status LED will single blink during this period.
4.3.2 Stopping a Recording Session
1. Press and hold the
PRESS
button. When the
STOP
(ORANGE) LED
lights up, release the button.
2. The GREEN LED will change from a double-blink to a single-blink,
indicating
STANDBY
mode.
The data will be retained, even if the instrument is in sleep mode. The
recorded data is stored in Flash memory (maintained even in the absence
of batteries). The recorded data may be downloaded to a computer.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
