7
f. Use the provided hex nuts(H) and
washers(G) to loosely fasten upper
and lower tubes to the rubber
mounts previously installed.
g.
Check for clearance around filter
between fog light housing and also
plastic liner. Adjust the position
of the lower tube if necessary.
Tighten hex nuts(H) and hose
clamps(C) once filter is properly
positioned. Reinstall lower belly
pan cover and plastic well liner.
h. Reconnect crank case breather
hose and recirculation valve hose
to upper tube(A) and fasten using
stock spring clamps as shown.
i. AEM cold air intake system
installed.
