AEG Thyro-A C01 Series, Operating Instructions Manual

Page: 38 / 48

38
2. Acyclic parameter table Thyro-C07
Table B: Thyro-C07 controller parameters slot 1-8
Controller parameter
Index
Symbol Name Data
type Value
range Combo-opt.
1 I_TYP Controller type current u16 0…
2 U_TYP Controller supply voltage u16 0…1000
3 P_TYP Controller type output power u32 0…
6 BETR Operating mode u16 0…3 reserved, TAKT, VAR, QTM
7 AN1 Phase angle of 1st half wave u16 0…180
8 SST u16 0…1000
9 SDN Soft stop duration (given) u16 0…1000
10 T0 Cycle period duration u16 0…1000
11 MP Minimum interval u16 0…10
12 TSMAX Maximum cycle turn on time u16 1…T0
13 TSMIN Minimum cycle turn on time u16 0…T0
14 V_IE Front pulse stop u16 0…180
15 H_IE Back pulse stop u16 0…180
16 RE Control (analog output value) u16 0…9 Uload2, Uload eff, Iload2, Iload eff, reserved, real power,
reserved, reserved, without regulation, temperature
17 TI_1 PI controller, I part u16 0= aus
0…65535
18 KP_1 PI controller, P part u16 0= aus
0…65535
19 KR_1 PI controller, counter P part u16 0…65535
20 Temperature coefficient of the heating tape u16 0…65535
21 UEMA Effective voltage setpoint maximum u16 0…
22 IEMA Effective current setpoint maximum u16 0…
23 PMA Power setpoint maximum u32 0…
24 SW_ENABLE Setpoint activation u16 0…3 bit0=1 setpoint x2.4 active, bit1=1 setpoint master active
27 SW_REGLER Setpoint x2.4 u16 0…4096
28 OF_1 Actual value output offset 1 u16 0…4096
29 FA_1 Scale end value actual value output 1 u16 0…4096
30 SPG_MIN Mains voltage monitoring min. u16 0…1000
31 SPG_MAX Mains voltage monitoring max. u16 0…1000
32 UN_S Undercurrent monitoring u16 0…1 off, on
33 RELAIS_CTRL_2 Relay configuration 2 u16 0…65535 bit coded
34 LASTBRUCH_MIN_
ABS Load fault, minimum value u16 0…4505
36 SYNC_ADR Synchro cycle address u16 0…65535
37 IMAB Pulse switch-off in case of failure u16 0…65535 bit coded
38 STA_RE Control start controller analog setpoint u16 0…65535
39 STE_RE Control end controller analog setpoint u16 0…65535
41 MOSI_FA Peak current value limit u16 0…4096
42 DAC_1_CTRL Analog output configuration 1 u16 0…11
44 VERS_T Version day u16 1…31
45 VERS_M Version month u16 1…12
46 VERS_J Version year u16 0…9999
48 Controller inhibit u16 0…1 off, on
49 RELAIS_CTRL Relay configuration 1 u16 0…65535 bit coded
50 Save u16 0…1 off, save
56 MITTEL Averaging analog output 1 u16 0…65535
84 TEMP Temperature u16 -50…150
109 MITTEL_2 Averaging analog output 2 u16 0…65535
110 OF_2 Actual value output offset 2 u16 0…4096
111 FA_2 Scale end value actual value output 2 u16 0…4096
112 DAC_2_CTRL Analog output configuration 2 u16 0…11
115 MITTEL_3 Averaging analog output 3 u16 0…65535
116 OF_3 Actual value output offset 3 u16 0…4096
117 FA_3 Scale end value actual value output 3 u16 0…4096
118 DAC_3_CTRL Analog output configuration 3 u16 0…11
119 U_MIN Voltage limit minimum u16 0…65535
120 U_MAX Voltage limit maximum u16 0…65535
121 I_MIN Current limit minimum u16 0…65535
122 I_MAX Current limit maximum u16 0…65535
123 P_MIN Power limit minimum u32 0…
124 P_MAX Power limit maximum u32 0…