19
D
GR
NL
F
GB
B
B
A
A
B
A
B
GB
3. Close the lid
(A)
and insert the
measuring cup in the fi ller hole and
(B)
lock into position. (You can use
the measuring cup to add ingredi-
ents while the blender is running.
Close the fi ller hole immediately
after, to avoid splashing.)
Caution! When processing hot
liquids, see step 4.
2.
Place the blender on a fl at surface
and lock the jug into position on the
motor housing. When the arrow is
aligned with the “Locked” indicator,
the jug is locked in position. Put the
ingredients in the jug.
(Do not exceed
the maximum level as indicated on
the jug.)
1. Before using the blender for the
fi rst time
, wash all parts except for
the motor housing.
Assembling:
Place the rubber seal on the blade
assembly
(A)
and insert it under
the jug. Turn the blade assembly
counter-clockwise
(B)
to fasten.
Caution! The blades are very
sharp!
5. Start the blender:
Make sure the
speed selector is set to the “OFF”-
position. Plug into mains.
Turn the
speed selector to your desired set-
ting.
Note:
Turn the speed selector to
“PULSE, ICE CRUSH” without releas-
ing it, to accelerate the process of
blending. Release to stop.
6. Ice crushing:
Turn the speed selec-
tor to “PULSE, ICE CRUSH” for 3-5
seconds several times until you
obtain a satisfactory result.
Note:
You can add more ice through
the fi ller hole while the blender is
running.
4. Processing hot liquids:
allow hot
liquids to cool down until lukewarm
before fi lling the jug. Fill the jug
only half full and start processing
on low speed.
The blender jug can
become very warm
– take care to
protect your hands and to ventilate
steam out through the fi ller hole.
Always replace the lid before use.
Getting started
AEG IFU SB 5700 BK.indd 19
AEG IFU SB 5700 BK.indd 19
17.01.14 15:32
17.01.14 15:32
