Programming your personal data
Attention:
Carry out the following operations one after the other and within a few seconds
or the device will automatically interrupt the programming mode!
1. Push the ON button to change to the programming mode. On the display (5), the
indication ‘P0’ (storage location) flashes.
2. Select a memory location with the
▲
/
▼
arrow keys.
3. Then push the
Set
button to start programming mode.
4. A female (13) or male (14) symbol fl ashes in the display. Use the
▲
/
▼
arrow keys to
select a setting.
Push the
Set
button again to change to the AGE menu. The indication ‘25’ flashes.
Push one of the arrow buttons and hold it down to run up or down through the numbers
quickly.
5. Use the arrow keys
▲
/
▼
to select a value between 10 and 85 years.
6. Push the
Set
button again to change to the HEIGHT menu. The indication ‘165’ flashes.
Use the
▲
/
▼
arrow buttons to select a value between 75 and 225 cm.
7. Pushing the
Set
button again will cause the storage location, sex, age and height ente-
red to be displayed for a few seconds, then the indication changes to ‘0.0’kg.
8. Now you can weigh yourself or push the
Set
button again to change back to the
‘Storage Location’ indication. There, you can choose between two possibilities:
a. Push the
Set
button again to view all settings.
b. To make any changes choose the storage location with the settings to be changed
(flashing indication) and push the
Set
button. Proceed as described in steps 4 to 6.
Your personal data is now stored in the selected storage location.
There is an overall number of 10 storage locations. The remaining 9 storage locations can
be used to store also the personal data of other members of your family or other users of
these scales.
Determination of the weight, body fat and body water percentage
First, enter your personal data in one of the storage locations available.
To switch the scales on use your foot to push the glass pane down and keep it pushed.
The display shows ‘888888’, then the storage locations are shown in ascending order.
Select the storage location where your data has been stored and let go of the glass pane.
Note:
Measuring is only possible with bare feet. If required, wipe the contact surfaces
clean to enhance conductibility. Put each of your bare feet on 2 of the 4 contact surfaces.
The display will now show your stored data and then changes to ‘0.0’kg (‘0.0’lb).
Now, keep your position on the scales.
• At fi rst your weight is shown in the display.
• Within a few seconds the scales calculate your body fat and body water ratio automati-
cally.
Wait until the measuring process is completed (the weight indication flashes 2x).
• The display then shows your body fat percentage (“FAT %” symbol), followed by the
body water percentage (“TBW %” symbol).
GB
63
I
PW_4908_Bed_Anl4.qxd 30.05.2006 9:33 Uhr Seite 63
