AEG KRC 4344, Instruction Manual

Page: 31 / 58

English
31
15 Speakers
16 Battery compartment
17 LCD display
Rear side (not shown)
Power cord
Wire antenna
Sub-structure assembly instructions
If you don’t want to use the device as a standalone appliance,
then please assemble it as follows:
ō 5HPRYHDOOREMHFWVIURPWKHFXSERDUGDQGDQ\WKLQJ
which is fragile in the adjacent cupboards.
ō )RUWKHLQVWDOODWLRQWKHFXSERDUGPXVWIXOğOWKHIROORZLQJ
conditions:
7KLFNQHVVRIWKHFXSERDUGĠRRU
between 16 mm and 20 mm.
ō 7KHZDOOPRXQWLQJRIWKHFXSERDUGPXVWEHVWDEOHDQG
anchored firmly in the wall with at least 2 screws.
ō
Important! Do not install the device above a cooker!
ō :KHQLQVWDOOLQJWKHGHYLFHLWPXVWEHHQVXUHGWKDWWKHUH
is a power socket within reach.
ō 7KHPDLQVVRFNHWPXVWEHZLWKLQHDV\UHDFKVRWKDWWKH
plug can be quickly removed in an emergency.
ō Important! Do not connect the device to the mains
power supply until after installation!
ō 7KHGHYLFHFDQQRWEHLQVWDOOHGXQGHUFXSERDUGVXQGHU
which there is a lighting strip.
ō )RUPRXQWLQJ\RXPD\QHHGWKHIROORZLQJVXSSOLHV
Reamer or nail, screwdriver, measuring tape, adhesive
tape, scissors, safety goggles.
Supplied mounting accessories
4 Screws (if necessary, check the battery compartment)
1 Drilling template
CAUTION:
ō 3OHDVHDGKHUHWRWKHGLPHQVLRQVVWDWHGLQWKHLQVWDOOD -
tion instructions.
ō <RXVKRXOGXVHRQO\WKHLQVWDOODWLRQDFFHVVRULHVVXS -
plied.
Installation
ō 6WLFNWKHWHPSODWHWRWKHERWWRPRIWKHZDOOFDELQHWZLWK
adhesive tape. With the help of a gimlet or nail pierce the
crosses at the attachment points and use it to mark the
holes.
ō 5HPRYHWKHPRXQWLQJSODWHIURPWKHGHYLFH7RGRVR
firmly press the mounting plate backwards.
ō 5HPRYHWKHWHPSODWHDQGğWWKHPRXQWLQJSODWHZLWKWKH
4 screws below the cabinet.
CAUTION:
ō 8VHDVFUHZGULYHUDQGQRWDFRUGOHVVVFUHZGULYHU
ō ,I\RXXVHGLIIHUHQWVFUHZVRULIWKHWKLFNQHVVRIWKH
FDELQHWĠRRULVWRRVPDOOWKHVFUHZVPD\SXVKWKURXJK
WKHFDELQHWĠRRU
ō 1RZKDQJWKHUDGLRRQWRWKHPRXQWLQJSODWHDQGSXVKLW
backwards until it clicks into place.
Start-up of the device / Introduction
ō 5HDGWKHRSHUDWLQJLQVWUXFWLRQVWKRURXJKO\EHIRUHWKH
start-up!
ō ,IDSSOLFDEOHUHPRYHWKHSURWHFWLYHğOPIURPWKHGLVSOD\
Location
ō )ROGRXWWKHVWDQGV
ō 6HOHFWDVXLWDEOHORFDWLRQIRUWKHGHYLFH6XLWDEOHZRXOG
be an even, non-slip surface on which you can easily
operate the device.
ō (QVXUHWKDWWKHGHYLFHLVDGHTXDWHO\YHQWLODWHG
Inserting the power reserve batteries
(Batteries not included)
In case of a power failure or if the power plug of the device
is disconnected from the outlet, then the settings will be
retained if the power reserve batteries have been inserted.
1. Open the battery compartment on the bottom.
2. Insert 2 AA/R6 1.5 V type batteries. Pay attention to the
correct polarity (see bottom of battery compartment)!
3. Close the battery compartment again.
4. If the device is not used for a long period of time, then
remove the batteries from the device to prevent the bat-
tery acid from leaking.
WARNING:
7KHEDWWHULHVVKDOOQRWEHH[SRVHGWRH[FHVVLYHKHDWVXFK
as sunshine, fire or the like. Danger of explosion!
CAUTION:
ō 'LIIHUHQWEDWWHU\W\SHVRUQHZDQGXVHGEDWWHULHVPD\
not be used together.
ō %DWWHULHVGRQRWEHORQJLQWKHKRXVHKROGZDVWH
Dispose of spent batteries at the designated collection
points or at the dealer.
Power supply
ō ,QVHUWWKHSOXJLQWRDSURSHUO\LQV]SRZHU
socket. 1- 1 0:00 will appear on the display. Please ensure
that the mains voltage corresponds to the information on
the type plate.
ō ,I\RXKDYHQRWLQVHUWHGDQ\SRZHUUHVHUYHEDWWHULHVWKH
preset time and radio stations are lost as soon as the
power supply has been interrupted.