42
English
WARNING
Do not abort the firmware update.
Once the firmware update has started it must be completed.
Wait until the update is fully completed. This may take a few min-
►
utes, but the operation cannot be aborted. Doing so may cause
permanent damage to the device.
Language: Set the language for the menu navigation.
■
Factory Reset : Reset radio to factory settings. All settings such as
■
language settings, network parameters etc. will be lost.
Register: only possible within the UK.
■
Set time/date: Set and select time and date settings with the
■
“SCROLL/ENTER” knob (3) .When connecting to LAN/WLAN, the
device will obtain this information automatically from the network.
Backlight: Set brightness for the display (8), using the “SCROLL/
■
ENTER” (3) knob.
Active: Display illuminated when using controls, i.e., when carry-
■
ing out settings on the device.
Inactive: Display illuminated after 30 seconds without using
■
controls.
Standby: Display illumination after device has been switched off
■
with the “I/ „ (5) button.
UPnP: Name, under which the IR 4430 should be visible as UPnP
■
device in the network. Specify the name as follows:
Select UPnP
Select Device Name
Use the “SCROLL/ENTER“ (3) knob to successively select and
move the characters of the name to the centre of the display.
Correct any wrong input with “BACK“ (18).
Complete the name input with the characters END .
WiFi strength: Displays the signal strength when connected to
■
WLAN.
Summary of Contents for IR 4430
Page 3: ...Übersicht der Bedienelemente 2 Location of Controls 3 ...
Page 57: ......