AEG EDW1103, Service Manual, Page: 34 / 59

SOE/PR 34 599 72 48-93
“iC1” – code: MACS bus communication
•
After three attempts to establish communication, an error is signalled in the hardware control
“iC2” – Code: ADSI communication
•
The washing programme is suspended but it can be restarted if the alarm conditions no longer apply
“iC3” – Code: Communication between the power board and the motor control board
•
The alarm is signalled if the communication between the mother board and the motor control board
does not start.
•
Acoustic signal and visual alarm, depending on the appliance customization; the washing program is
restarted automatically if the error conditions no longer apply.
“iD0” Code - family : Tacho Problem
“iD0” – code: no signal
•
The alarm is stored and displayed only in service mode; there is a new control for each new phase.
•
If the washing pump is activated but there is no tacho signal for 30 sec then the motor speed is set to
full speed and the heating element is not activated.
“iD1” – code: no signal
•
The alarm is stored and displayed only in service mode.
•
If the washing pump is activated but there is no tacho signal for 5 sec then the heating element is
temporarily deactivated. If after another 30 sec there is still no signal the appliance displays an error
code iD0.
“iE0” – family: flow controller problem
“iE0” – code: flow control position (spray arm level)
•
The alarm is stored and displayed only in service mode; there is a new control for each new phase.
•
The alarm is signalled if the desired position of the flow controller is not reached after 120 sec; the
•
heating element is deactivated.
•
If the signal from the flow controller does not change after 15 sec, the software suspends the
positioning for 2 sec and resumes after another max 120 sec.
“iF0” Code - family : water level problem
“iF0” – Code : overfilling detected
•
The alarm is stored and displayed only in service mode; the program continues.
•
The error situation is recognized when the total filling times exceed the limits.
•
The times are accumulated at each subsequent filling and reset every time the drain is activated.
•
If the alarm is detected, the heating element is not activated and the subsequent fillings are ignored.