Advantech TPC-300 Series, User Manual

Page: 5 / 88

v TPC-300 Series, TPC-B510 User Manual
Safety Instructions
1. Read these safety instructions carefully.
2. Retain this user manual for future reference.
3. Disconnect the equipment from all power outlets before cleaning. Use only a
damp cloth for cleaning. Do not use liquid or spray detergents.
4. For pluggable equipment, the power outlet socket must be located near the
equipment and easily accessible.
5. Protect the equipment from humidity.
6. Do not expose the equipment to direct sunlight, or install the equipment in an
environment with direct sunlight, as this may cause damage.
7. Place the equipment on a reliable surface during installation. Dropping or letting
the equipment fall may cause damage.
8. The openings on the enclosure are for air convection. Protect the equipment
from overheating. Do not cover the openings.
9. Ensure that the voltage of the power source is correct before connecting the
equipment to a power outlet.
10. Position the power cord away from high-traffic areas. Do not place anything over
the power cord.
11. All cautions and warnings on the equipment should be noted.
12. If the equipment is not used for a long time, disconnect it from the power source
to avoid damage from transient overvoltage.
13. Be aware that the rear cover may become quite hot during operation. To avoid
scalding or personal injury, do not touch the rear cover.
14. Never pour any liquid into an opening. This may cause fire or electric shock.
15. Never open the equipment. For safety reasons, the equipment should be
opened only by qualified service personnel.
16. If one of the following occurs, have the equipment checked by qualified service
personnel:

The power cord or plug is damaged.

Liquid has penetrated the equipment.

The equipment has been exposed to moisture.

The equipment is malfunctioning or does not work according to the user
manual.

The equipment has been dropped and damaged.

The equipment shows obvious signs of breakage.
17. Do not leave the equipment in an environment with a storage temperature of
below -20 °C (-4 °F) or above 60 °C (140 °F) as this may cause damage. The
equipment should be located in a controlled environment.
18. Batteries are at risk of exploding if incorrectly replaced or installed. Replace only
with the same or equivalent type recommended by the manufacturer. Discard
used batteries according to the manufacturer’s instructions.
19. Danger d'explosion si la pile est remplacée de fa?on incorrecte. Remplacez
seulement avec le même type ou équivalent recommandé par le fabricant. Dis -
poser des piles usagées selon les instructions du fabricant.
20. The equipment is intended to be installed on a wall or in a cabinet with the fol -
lowing conditions: access is restricted to service personnel or users who are
aware of all precautions that must be taken when using the equipment; access
can only be gained with the use of a key or other means of security; access is
controlled by the authority responsible for the location.
21. In accordance with the IEC 704-1:1982 specifications, the sound pressure level
at the operator’s position does not exceed 70 dB (A).