Advantage BG-N4 Series, Instruction Manual

Page: 37 / 76

BG-N4 Glycol Chiller
Page: 37
ADVANTAGE ENGINEERING, INC.
525 East Stop 18 Road Greenwood, Indiana 46142
317-887-0729 Fax: 317-881-1277
Service Department Fax: 317-885-8683
Email: service@AdvantageEngineering.com
setpoint below 48°F is entered. The warning ensures the operator is aware the
an appropriate mixture of water/glycol is circulating to prevent freezing.
2. After a minimum setpoint below 48°F is selected, a caution display will appear
when reducing the operating setpoint below 48°F. The warning must be
acknowledged before the change is made by pressing the Select button.
3. For Minimum Setpoints 48°F and above. From the Machine Menu, advance
to the Minimum Setpoint screen to enter the minimum setpoint. Confirm the
selection with the Select Button.
E. Hi Temp Shutdown. This shuts down the unit if process temperature exceeds the
selected value to prevent excessively warm fluid temperature.
1. From the Machine Menu, select Hi Temp Shutdown via the Up or Down Arrow
keys. Adjust the temperature as desired. Select button to save and confirm
success.
2. The factory default value is 100°F. The range is from 65°F - 110°F.
F. Units. This screen controls how the temperature is displayed. The options are English
(°F) or Metric(°C). Also, when the optional flow meter is installed, the flow will display in
GPM if English is selected or LPM if Metric is selected.
1. Use the Up or Down arrow keys to select the Unit display and then press the
Select button to save and confirm success.
Minimum Setpoint
48°F
Back Adjust OK
Machine
Set Date
Set Time
Min Setpoint
Hi Temp Shutdown
Units
Back Pick Go
FLow
Enable
Offset
Calibration
To Process
50°F
Change Setting
Minimum Setpoint
Success
Acknowledge
To Process
S e t p o i n t : 5 0 ° F
C i r c u l a t i n g
50°F
To Process
S e t p o i n t : 5 0 ° F
50°F
Glycol required
for this setpoint
S e t p o i n t : 4 7 ° F
O u t p u t s
■
• • • O u t p u t s
■
• • •
ATTENTION
Hi Temp Shutdown
100°F
Back Adjust OK
Machine
Set Date
Set Time
Min Setpoint
Hi Temp Shutdown
Units
Back Pick Go
FLow
Enable
Offset
Calibration
To Process
50°F
Change Setting
Hi Temp Shutdown
Success
Acknowledge
Units
English
Metric
Back Adjust OK
Machine
Set Date
Set Time
Min Setpoint
Hi Temp Shutdown
Units
Back Pick Go
FLow
Enable
Offset
Calibration
To Process
50°F
Change Setting
Units
Success
Acknowledge