Advantage Engineering Maximum, Instruction Manual

Page: 33 / 80

MK Series Portable Chiller : Air-Cooled : HE INSTRUMENT
Page: 33
ADVANTAGE ENGINEERING, INC.
525 East Stop 18 Road Greenwood, Indiana 46142
317-887-0729 Fax: 317-881-1277
Service Department Fax: 317-885-8683
Email: service@AdvantageEngineering.com
h. Prb: programs the ‘from process’ probe calibration.
Use this to fine tune the ‘from process’ probe to
display the same temperature as the ‘to process’
probe, assuming a temperature equilibrium.
i. LPt: programs the low pressure time delay. This can
avoid nuisance defaults on the low pressure switch
when the compressor is unable to rebuild pressure
within the time delay. Check with the factory
service department before altering this parameter.
F. FLOW DISPLAY
(figure 3.3E)
1. The FLOW display shows information concerning the pump
generated flow. The flow measuring mechanism is installed
in the ‘from process’ water line. Typically, an internal flow
sensor is provided with the chiller. In some cases, a larger
external flow sensor is provided.
a. PUMP ON: illuminates when the pump is
operating.
b. LPM: illuminates to indicate flow display in liters
per minute . This light illuminates when the ‘Unt’
parameter was toggled to ‘C’.
c. GPM: illuminates to indicate flow display in gallons
per minute . This light illuminates when the ‘Unt’
parameter was toggled to ‘F’.
G. CAPACITY % DISPLAY
(figure 3.3F)
Figure 3.3E
Figure 3.3F