www.advancedco.com
13
2.3.1.1.2 Battery
The batteries must be located on the battery shelf behind the module or in the bottom of the enclosure. Fit the
Mxp-501 Battery Remote Temperature Sensor to ensure that the batteries are charged at the correct voltage.
Plug the Mxp-501 into the connector and route the sensor cable along with the battery leads. Use the supplied
tie-wraps to tie the sensor cable to the battery leads so that the encapsulated sensor is located close to the
batteries. The sensor cable is 500mm in length.
NOTE: If the base card is not fitted with either a jumper or a remote temperature sensor the panel will indicate a
charger failure condition. Ensure that the jumper is replaced if the remote sensor is removed / not used.
W A R N IN G :
H IG H V O L T A G E IN S ID E
D O N O T R E M O V E C O V E R
N o S e rv ic e a b le P a rts In s id e
Jumper
– centre two pins
Battery Leads
Sensor
Summary of Contents for Mx-5101xR
Page 23: ...www advancedco com USER NOTES...
