Advanced Mx-5101xR, User Manual

Page: 12 / 24

www.advancedco.com
12
When the panel module is mounted in large
floor standing rack enclosures, fit the MXM-
MXM-534 loop card support plate as shown
opposite.
Remove the three screws fixing the display
card and replace with the supplied pillars.
Mount the plate onto the pillars and fix in place
using the supplied screws.
2.3.1.1 Wiring
Cable entry holes are provided for installation wiring
– two on the right hand side for AC Supply and Battery
Supply
– one on the left for internal wiring. Also on the left (top) is a U channel cut-out for routing field wiring to
the side frame of the enclosure.
Cable tie anchor points are provided at strategic locations to tie down the wiring.
Refer to the wiring section of the product manual 680-165 for full information. The AC Supply and Battery
Supply connections are re-iterated below for reference.
2.3.1.1.1 AC Supply
Route the high voltage mains AC wiring into the
enclosure at the upper right corner only. Keep the
AC wiring away from the circuit boards and all
other wiring. The mains input connector is shown in the
diagram below. Note the positions of the earth,
neutral and live terminal connections. These are
clearly marked on the label next to the connector.
The connector block contains an integral fuse
holder.
F U S E
B ro w n
G reen
L IV E
E A R T H
N E U T R A L
P a n el W irin g
B lu e
3 .1 5 A
AC Mains terminations
The fuse is rated as follows:
T 3.15A H 250V
Replace with correct rating and specification only.
M u s t b e
e a rth e d
The panels must be connected to
the supply earth through the power
cable.
Secure the mains input wiring by tie wrap as close
to the terminal block as possible.
Connect the Control Panel to the mains supply via
a readily accessible disconnect-device (Isolation
Switch) and suitable earth fault protection
incorporated in the building installation wiring. The
Mains cable should be 0.75mm
2 cable rated at
250V and fused via a 5A anti-surge fuse.
NOTE: If two or more power supplies are installed
then an MXP-514 AC Filter card kit must be
installed in the back box. Refer to Section 2.3.5 for
more details.
M3 Pillars MXM-534 Plate
Order separately