4/2017
A - 41
56091206 - CS7010
ENGLISH - A
INSTRUCTIONS FOR USE
GENERAL MACHINE TROUBLESHOOTING
Before you start troubleshooting, check to make sure:
• the emergency stop switch
(B)
on the operator control panel is disengaged (rotate clockwise).
• the seat switch is closed.
• the battery stop plate
(AC)
is in place (battery models).
• reset any tripped circuit breakers.
Problem
Possible Cause
Remedy
Poor water pick-up
Worn or torn squeegee blades
Reverse or replace
Squeegee out of adjustment
Adjust so blades touch
fl
oor evenly
across entire width
Recovery tank full
Empty recovery tank
Recovery tank drain hose leak
Secure drain hose cap or replace
Recovery tank cover gasket leak
Replace gasket / Seat cover properly
Debris caught in squeegee
Clean squeegee tool
Vacuum hose clogged
Remove debris
Using too much solution
Reduce
fl
ow via control panel solution
decrease switch
Poor scrubbing performance
Worn brush
Rotate or replace brushes
Wrong brush type
Consult Advance
Wrong cleaning chemical
Consult Advance
Moving machine too fast
Slow down
Not using enough solution
Increase
fl
ow via control panel solution
increase switch
Incorrect detergent ratio
Verify concentration setting if EcoFlex
equipped.
Poor sweeping performance
Broom out of adjustment
Adjust broom
Hopper full
Empty hopper
Broom bristles worn or curved
Replace or rotate broom
Broom housing skirts damaged or worn
Replace skirts
Broom not turning
See service manual
Inadequate solution
fl
ow
or no solution
Solution tank empty
Fill solution tank
Solution lines, valve or
fi
lter clogged
Flush lines & valve / clean solution
fi
lter
Solution turned OFF
Activate
fl
ow via control panel solution switch /
verify shutoff valve is in open position
Solution solenoid valve plugged or
defective
Clean or replace valve
(see service manual)
