A - 36
CS7010 - 56091206
4/2017
INSTRUCTIONS FOR USE
A - ENGLISH
C36
SIDE BROOM MAINTENANCE
The side brooms move dirt and debris away from walls or curbs and into
the path of the main broom. Adjust the side brooms so that the bristles are
contacting the
fl
oor from the
(FG)
to
(FH)
area shown in
Figure 19
when the
broom is down and running.
To adjust the Side Broom:
1.
Press the One-Touch™ Sweep Switch
(Y)
to lower the side brooms. DO
NOT move the machine.
2.
See Figures 18A and 18B.
To adjust, press the Broom Select Switch
(AA)
once. The LCD Display
(C)
will show the side broom symbol
C36)
.
Press and hold the Broom Height Raise Switch
(Z)
to raise the side brooms
or Broom Height Lower Switch
(BB)
to lower the side brooms. After 10
seconds without adjustment the side brooms will be set at this position and
exit the adjustment menu.
NOTE:
The machine should be stored with the Side Broom(s) in the raised position. The Side Broom(s) should be replaced when the bristles
are worn to a length of 3 inches (7.62 cm) or they become ineffective.
To replace the Side Broom:
1.
Raise the Side Broom(s).
2.
See Figure 19.
Reach under the Side Broom and remove the large Thumb-Nut Weldment holding the side broom on and remove the broom
and plastic disc.
NOTE:
The right side Thumb-Nut has right handed threads and the left side thumb-nut has left handed threads.
3.
Install the new broom and plastic disc by aligning the three alignment pins and pushing on. Re-install the Thumb-Nut and tighten.
FIGURE 19
FIGURE 18B
FH
FG
FG
FH
