A - 52
CS7010 - 56091206
4/2017
INSTRUCTIONS FOR USE
A - ENGLISH
Material Composition and Recyclability
Type
% of machine weight
Petrol / LPG
% of machine weight
Diesel
% of machine weight
Battery
% recyclable
Aluminum
0.5%
0.5%
0.3%
88%
Electrical / motors / engines - misc
27%
29.3%
50.1%
95%
Ferrous metals
53.8%
51%
35.2%
95%
Harnesses / cables
1.1%
1.2%
0.9%
74%
Liquids
0.7%
0.7%
0.9%
95%
Plastic - non-recyclable
1.5%
1.8%
1.1%
0%
Plastic - recyclable
0.9%
0.7%
0.4%
91%
Polyethylene
12%
12.3%
9.2%
100%
Rubber
2.5%
2.5%
1.9%
60%
CS7010 FUEL CELL MODEL – OPERATING INSTRUCTIONS
Operation:
•
Do not turn the fuel cell module off while the machine is in operation!
Always turn the machine off
fi
rst, and then turn the fuel cell
module off.
•
For operating, refueling, safety, or service information speci
fi
c to the fuel cell module, refer to the manufacturer’s publications.
•
The following fuel cell hybrid modules have been evaluated and are approved for use in this equipment:
•
Plug_Power, Inc. model 2300 Gen-Drive hybrid fuel cell module
•
Limitations: The fuel cell module listed above is intended for use in normal warehouse or other moderate-duty
applications. It is intended for indoor use only. It may not be suitable for severe-duty applications such as rough
surface cleaning/sweeping or severe inclines.
•
For operating, safety, or service information speci
fi
c to the CS7010, refer to the appropriate Nil
fi
sk documentation.
Cleaning of Machine:
•
FUEL CELL MODULE SHOULD NOT GET WET!
Cleaning of the CS7010 should be done in accordance with instructions in the
machine operating manual with the following important note: The fuel cell module should not be subjected to water or solution spray or
indirect contact.
•
Do not spray or pour water over the top of the machine as liquid may run between machine panels onto the fuel cell module.
•
Keep water spray below the fuel cell compartment.
•
Do not spray water or solution into the side grille openings.
Fuel Cell Installation or Removal:
•
Follow standard battery installation and removal procedures. Module must be installed or removed using a battery roll-out cart with
minimum capacity rating of 2300 LBS (1050 kg).
•
Install the module with the refueling port on the operator side of the machine.
Installation or Removal of Fuel Cell Module User Interface Panel:
•
Refer to “Fuel Cell Module User Interface Panel” instruction sheet.
